Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Construction in Daly City, CA | Workshop Contractors
We install, reface, and repair CGI cabinetry and vanity lines across Daly City as an independent contractor, not a manufacturer rep. The thing that sets our CGI work apart here is that we treat every cabinet install as a structural and moisture problem first, because Daly City’s dune-sand lots and salt-wet fog will expose a bad substrate faster than any product flaw will. If your kitchen or bath needs CGI boxes, doors, or full runs set square and sealed against this climate, call Noel Figueroa’s team at Workshop Contractors at (844) 384-3361.
Why Daly City Residents Choose Us for CGI Service
We have pulled Daly City permits, dug footings into loose dune sand, and set kitchen and bath packages into mid-century stucco tract homes from the 1940s through the 1970s. That matters because CGI’s European frameless cabinetry, RTA shaker lines, and quartz-look vanity tops live or die by what they are fastened to. We know how the brand’s full-overlay doors behave in damp air, how the particleboard boxes react to a sweating galvanized supply line behind a sink base, and how much movement a settled slab can put through a cabinet run before a hinge lets go. Noel Figueroa grew up around tradesmen who taught framing before he could rent a truck, and he has carried that same habit into cabinet work: the box has to be square, the wall behind it dry, and the floor under it stable. You can learn more about our full CGI sales & service scope here. We serve every ZIP in Daly City service area: 94014, 94015, 94016, and 94017.
Styles & brands we work with
Common CGI Construction Problems We Solve in Daly City
- Thermofoil and laminate door skins peeling at the bottom rails. Daly City’s salt-laden onshore wind and persistent damp work into the door edge first. We see cabinets facing the ocean side lose their skin within a few seasons if the doors were not sealed at the cut edge.
- Particleboard and MDF boxes swelling at the toe kick. Where a rear addition or in-law unit meets an old slab-on-grade, ground moisture wicks up. The base cabinets near those exterior walls swell, the doors stop closing square, and shimming makes it worse.
- Frameless hinges and euro screws pulling out of softened board. Pre-1970s Daly City homes often have galvanized supply lines that sweat and slow-leak behind the cabinet back. By the time the homeowner notices, the screw holes are mush.
- Cabinet runs thrown out of level by old fill settlement. Heavy winter rain moves the loose sand and slip-prone fill under these floors. The cabinet doors rack, the drawers bind, and the countertop seams open up.
- Laminate end panels faded and chalked on south and west walls. When the fog burns off in the afternoon, the UV hits hard. On a hillside lot near Serramonte, that afternoon sun will chalk a laminate panel in a way the north side of the same house never sees.
CGI Service in Daly City: What Local Conditions Mean for Your Equipment
Daly City is built almost entirely on foggy, wind-scoured sand dunes and steep slopes above the Pacific. Even flat-looking lots near Westlake or Serramonte sit on loose dune sand or old fill that shifts after heavy winter rain. So when a kitchen or bath remodel opens a rear wall, we often have to re-level or underpin the floor before any cabinet goes in. The floor movement under the cabinet run is what fails first here, not the cabinets. That is why we put a moisture barrier and corrosion-resistant fasteners in before a single CGI box gets set. A homeowner in CGI in Colma or Pacifica deals with different ground and different wind patterns; in Daly City, if the substrate is wrong, the best cabinet on the market will not stay square through one winter. Build it right the first time. The second time costs twice as much and nobody’s happy about it.
CGI Models & Products We Service in Daly City
We install, reface, and repair the full CGI by Wilsonart line:
- European Frameless cabinetry – full-overlay, particleboard/MDF boxes with thermofoil or laminate doors.
- Ready-to-Assemble shaker and raised-panel lines sold through building-supply channels.
- Laminate and quartz-look vanity tops and cabinet-matched bath cabinetry.
- Frameless pantry and utility cabinet units used in tight in-law and addition layouts, which Daly City has plenty of.
Our parts approach is honest. We match CGI OEM hinges, drawer glides, shelf clips, and door fronts wherever the line is still supported. When OEM is discontinued or the original part was the weak link, we switch to quality aftermarket hardware and tell you why. For Daly City turnaround, we keep common euro hinges, slides, and shelf clips stocked locally so a single-cabinet repair does not sit waiting on a parts order.
See the difference
Before
After
Before
After
Before
AfterCGI Service Pricing in Daly City
Here are the ranges we quote for the work we do across Daly City. These are total job ranges, not just cabinet line items.
| Service | Typical Range in Daly City |
|---|---|
| Kitchen Remodel | $14,000 – $45,000 |
| Small Kitchen Remodel | $9,000 – $20,000 |
| Cabinet Installation | $4,000 – $13,000 |
| Countertop Installation | $2,000 – $6,500 |
| Backsplash Installation | $800 – $2,500 |
| Kitchen Island Installation | $3,000 – $10,000 |
| Bathroom Remodel | $9,000 – $28,000 |
| Small Bathroom Remodel | $5,000 – $12,000 |
| Walk-In Shower Installation | $4,500 – $12,000 |
| Tub-to-Shower Conversion | $3,500 – $10,000 |
| Shower Replacement | $3,000 – $8,500 |
| Bathroom Vanity Installation | $800 – $3,000 |
| Roof Replacement | $8,000 – $20,000 |
| Roof Repair | $400 – $1,800 |
What drives the number in Daly City is almost always the substrate: floor leveling, moisture barrier, or lateral bracing on a pre-1970s frame. A free estimate from us includes that look behind the cabinet, not just a door measurement. Call (844) 384-3361 and we will give you a written line-item quote.
Serving Daly City, CA — Our Local Coverage Area
We’re based in the Daly City area and also offer Brisbane CGI service, so we know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – CGI Construction in Daly City
Yes, if the boxes go into a dry, square opening with sealed edges and good hardware. The failures we see in Daly City are almost always moisture and movement problems behind the cabinet, not the cabinet itself. Call (844) 384-3361 and we will inspect the wall and floor before we quote you.
Often, yes. Pre-1970s stick frames in Daly City were not built for current lateral loads, and many of these homes sit on old fill that has shifted. When we open a wall or re-level a floor for a cabinet run, the city may require bracing or footing upgrades as part of the permit. We pull those permits and do that work in the same contract.
No, not in Daly City. Shimmed cabinets on a shifting floor will rack and bind within a season or two. We re-level or underpin the floor first, then set the cabinets. On a 1950s stucco tract home above Westlake, we opened a kitchen wall for a CGI service in Broadmoor style frameless package and found the rear floor had settled several inches on old fill. We re-leveled that floor, added a moisture barrier, and the cabinet run has stayed square through two winters of heavy rain. Call (844) 384-3361 for a floor assessment before you buy cabinets.
We waterproof that shared wall as if it were an exterior wall, which in Daly City’s damp it practically is. That means moisture barrier, sealed penetrations, and corrosion-resistant fasteners. Then we set the CGI service in Visitacion Valley vanity and any cabinet runs level and anchored to framing, not drywall. Call (844) 384-3361 and we will walk the wall with you before we quote.
Refacing existing cabinets usually does not. But if your project opens walls, moves plumbing, re-levels a floor, or touches a rear addition on a sloping lot, the city will want a permit and likely a grading or structural sign-off. We handle that for you. Call (844) 384-3361 and we will tell you what your specific scope triggers.
Service Areas Near Daly City
We run CGI work throughout the peninsula and down into the South Bay. Common stops include CGI service in Mission District, CGI service in Noe Valley, plus South San Francisco, Pacifica, and Colma. Same team, same truck, same standard.
Book Your CGI Service in Daly City Today
Call Noel Figueroa’s team at Workshop Contractors at (844) 384-3361. We will schedule a walkthrough of your Daly City home, check the floor and the wall behind the cabinets, and give you a free written estimate. One contractor, every trade, from the roof down to the pavers.
Written by Noel Figueroa, Owner at Workshop Contractors, serving Daly City since he first set footings into its dune sand.