Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Unilock Construction in Daly City, CA | Workshop Contractors
We install, repair, and re-level Unilock paver systems across Daly City, and the one thing that sets our work apart here is that we treat every paver job as a drainage and base problem first, because that’s what Daly City’s dune sand and fog belt actually demand. Noel Figueroa and our crew have worked Unilock surfaces on slopes, on fill, and against rear additions all over the 94014, 94015, 94016, and 94017 ZIP codes. We’re an independent contractor, not a Unilock dealer or authorized service arm. We stock genuine Unilock units and compatible polymeric sand, and we quote every job in writing before work starts. If you’re pricing a Unilock driveway, patio, or re-level in Daly City, call (844) 384-3361 for a free estimate.
Why Daly City Residents Choose Us for Unilock Service
We carry Unilock sales & service experience from hundreds of paver surfaces across the Bay Area, but what Daly City homeowners respond to is that we already know their ground. Noel Figueroa got his start on job sites before he was old enough to rent a truck, and he has spent decades since learning what actually causes hardscape failure: water, bad base prep, and edges that were never anchored. Around here, those three problems show up in very specific ways. Fog-saturated sand, old fill under mid-century lots, and steep driveways that shed water straight toward the garage. We plan for those conditions before we lay a single paver. That’s the difference between a patio that holds its lines through five winters and one that starts rocking by March. We’re a single-source contractor, which means the same team that diagnoses your paver settlement also understands how that water interacts with your stucco wall base, your garage slab, and your rear addition.
Styles & brands we work with
Common Unilock Construction Problems We Solve in Daly City
Here’s what we actually see when we get called out to Unilock surfaces in Daly City:
- Pavers pumping and rocking after winter rains. The loose dune sand under many older Daly City bases was never compacted in proper lifts. Water gets in, the sand shifts, and joints open up. We lift the affected area, re-base it, and reset the original units whenever they’re still sound.
- Edge restraint lift-and-roll on sloping driveways. This is common on the canyon-edge lots around Westlake and Serramonte. When polymeric joint sand washes out and the shoulder was never set into a concrete collar, the outer course starts to roll. We rebuild the edge with a true restraint system, not just more sand.
- Chalky, effloresced paver surfaces. The salt-laden onshore fog here does something inland cities never deal with: it drives mineral deposits up through older Brussels Block and other concrete pavers, especially where sealer has failed. We clean, treat, and re-seal with a fog-appropriate product.
- Standing water against rear additions and in-law units. Tight lots mean patios get built right up against a stucco wall. If the paver grade never carried positive slope away from the house, water pools and wicks into the wall base. We re-establish drainage before resetting the surface.
- Driveways that have settled at the garage transition. Sloping driveways in Daly City shed water hard. If the base at the garage apron wasn’t built with a drain, the pavers settle and then funnel water under the door. We’ve corrected this more times than we can count.
Unilock Service in Daly City: What Local Conditions Mean for Your Equipment
Daly City is built almost entirely on foggy, wind-scoured sand dunes and steep slopes above the Pacific. Construction here is fundamentally a soil-stabilization and drainage problem. That’s not a metaphor; it’s the geotechnical reality. Even flat-looking lots in the 94015 ZIP code sit on loose dune sand or slip-prone fill, and the canyon-edge lots around Serramonte and Westlake can shift after heavy winter rains. A Unilock driveway or patio in Daly City succeeds or fails on slope drainage and footing-depth details, not on the paver surface itself. We’ve seen identical Unilock Town Hall patios built the same week: one on a compacted base with a concrete edge collar, one on sand with a plastic snap edge. The first one held through two wet winters. The second was rocking by February. On a sloped driveway off the Westlake side, our crew lifted a Brussels Block apron that had rocked and pumped all winter, found the base laid over loose dune sand without proper compaction or a concrete edge collar, and rebuilt it in compacted lifts with a positive drain away from the garage. We reset the original pavers with fresh polymeric sand and added a restrained edge, and the driveway has stayed tight through the next rainy season.
Unilock Models & Products We Service in Daly City
We work with the Unilock lines that show up most often on Daly City properties: Brussels Block, Beacon Hill, Town Hall, and Seno. Brussels Block remains the workhorse driveway and walkway paver in older mid-century neighborhoods, and we know its wear patterns, its sealer failures, and how it reads after ten years of fog exposure. Beacon Hill and Town Hall show up on patios and garden paths, and Seno appears on newer builds and contemporary additions. When we do repairs, we source genuine Unilock units matching the existing profile and color blend. We don’t substitute box-store lookalikes, because the joint lines never read right. For polymeric sand and edge restraints we use compatible products engineered for coastal exposure, not whatever is cheapest at the supply yard. Most Unilock surfaces in Daly City can be lifted, re-based, and re-sanded rather than fully replaced. We only push full replacement when base failure or slope drainage can’t be corrected in place.
See the difference
Before
After
Before
After
Before
AfterUnilock Service Pricing in Daly City
| Service | Typical Range in Daly City |
|---|---|
| Paver Driveway Installation | $7,000 – $18,000 |
| Paver Patio Installation | $3,500 – $11,000 |
| Driveway Replacement | $5,000 – $14,000 |
| Driveway Sealing | $250 – $700 |
What drives the cost up here is slope: a steep driveway needs more excavation, more base material, deeper footings, and a real drainage plan. A flat patio behind a rancher in the 94014 ZIP is a different job from a tiered patio on a canyon-edge lot. Our free estimates include a written line-item quote, and we walk the site with you so you understand what’s being built and why. Call (844) 384-3361 to schedule one.
Serving Daly City, CA — Our Local Coverage Area
We’re based in the Daly City area and know this community well, including nearby Unilock in Colma. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Unilock Construction in Daly City
Your pavers are almost certainly sitting on a base that was never compacted in proper lifts over Daly City’s loose dune sand or old fill. Winter rain moves through the joints, saturates that uncompacted material, and the base pumps. The fix is to lift the affected area, re-grade, compact in lifts, and reset the pavers with fresh polymeric sand. We do this daily. Call (844) 384-3361 for a site evaluation.
Yes, on any surface with meaningful grade. A plastic snap edge or a shallow sand shoulder will not hold the outer course on a Westlake, Brisbane Unilock service area, or Serramonte slope. We set edge restraints into a concrete collar so the whole surface acts as one unit. Without that, the edge rolls and every course behind it follows.
In most cases, yes. We lift the settled units, re-compact the base, correct any drainage issue, and reset the original pavers with new polymeric sand. Brussels Block and Beacon Hill both tolerate this well. Full replacement only happens when the base itself has failed or the pavers are cracked beyond saving.
That’s the fog. Daly City sits in a persistent coastal fog belt, and the salt-laden onshore air drives efflorescence and surface erosion on concrete pavers, especially older Brussels Block with failing sealer, something we also address with Unilock service in Broadmoor. We clean the surface, treat the mineral deposits, and apply a sealer designed for coastal exposure. It won’t work forever, but it will last years longer than nothing.
You can, but drainage has to be planned from day one. Many Daly City lots, like those needing Unilock service in Visitacion Valley, already have an in-law unit or rear addition, and the space behind them is often tight and partly shaded. If the paver grade does not carry water away from the structure, you’ll get pooling and wicking into the stucco wall base. We design those small patios with positive slope and, where needed, a strip drain along the wall. Call (844) 384-3361 and we’ll walk the site with you.
Service Areas Near Daly City
We serve Daly City and the surrounding communities. Our Daly City service area includes the neighborhoods around Westlake, Serramonte, St. Francis, and the areas near the Pacific coast. We also run Unilock work in Unilock service in Mission District and Unilock service in Noe Valley for clients whose projects sit on the north side of the hill. If you’re nearby and wondering whether we cover your street, call and ask.
Book Your Unilock Service in Daly City Today
If your Unilock driveway is rocking, your patio is holding water, or you’re planning new hardscape on a Daly City slope, we’ll put eyes on it. We quote free, we write everything down, and we build for the ground you actually have. Call (844) 384-3361 to schedule your free estimate.
Written by Noel Figueroa, Owner at Workshop Contractors, serving Daly City since 2005. His grandfather built the family’s house in Pomona with his own hands, and Noel has never gotten over the idea that a well-built structure is the most honest thing a person can leave behind. Build it right the first time. The second time costs twice as much and nobody’s happy about it.